Hi community,
I've exported ESD4 project to eclipse format and i've succefully ported the library to renesas synergy platform!
I use it because I can previsualize screen before code them and there is more widgets than with ESE.
But I have many questions and recommandations for Bridgetek developppers and community:
1) There are lot of warnings in the project (about 3300). It's mainly conversion variable formats and definition function problems. Can you correct this?
2) When you use NULL constants include of stddef.h is missing.
3) In ft_esd_cocmd_widgets.c include of stdarg.h is missing for va_arg() function use.
4) I have a matrix orbital screen without touch screen since I'm using a keypad appart: library is not optimized for TPN screen references. Is it possible to autodetect that a touchscreen controller is physically present or not with BT815? Or add a define to support TPN configuration? I must consequently disable esd_calibrate() function.
5) If there is no SPI flash connected to BT815, is it possible to display bitmaps? I have only the flash on my MCU and maybe SPI flash extension later. Library is also not optimized for non SPI flash devices.
6) I have 4.3inch 480x272 resolution WQVGA screen and I've edited EVE_config.h to make it work with :
#ifndef EVE_DISPLAY_AVAILABLE
#define EVE_DISPLAY_AVAILABLE
#define DISPLAY_RESOLUTION_WQVGA //WVGA before
#endif
As you can see, when I export to eclipse project I must modify several files each time to compile successfully my project. It's borring...
The other solution is to export outside my project and copy only modified files...
Regards.