1
Discussion - EVE / Riverdi RVT50HQBFWCA0 - screen shift after PoR
« on: May 15, 2023, 09:28:06 PM »
Hello colleagues,
I am currently using the Riverdi RVT50HQBFWCA0 display with the BT817Q driver. Sometimes I'm facing the issue during the power-on-reset (POR) start, where the screen shifts to the upper left side, as shown in the attached photo.
However, after reinitialization, everything starts working fine. Additionally, I do not observe this behavior after a software reset at all. Interestingly, during the occurrence of this problem, the touch elements appear to be in the correct positions, indicating that only the printed display is shifted.
When the issue arises, I have checked all my configuration registers and the values appear to be correct.
I am seeking assistance to understand the possible cause of this problem or if there is a specific register I should be monitoring to detect when this issue occurs.
Thank you for your help:)
I am currently using the Riverdi RVT50HQBFWCA0 display with the BT817Q driver. Sometimes I'm facing the issue during the power-on-reset (POR) start, where the screen shifts to the upper left side, as shown in the attached photo.
However, after reinitialization, everything starts working fine. Additionally, I do not observe this behavior after a software reset at all. Interestingly, during the occurrence of this problem, the touch elements appear to be in the correct positions, indicating that only the printed display is shifted.
When the issue arises, I have checked all my configuration registers and the values appear to be correct.
I am seeking assistance to understand the possible cause of this problem or if there is a specific register I should be monitoring to detect when this issue occurs.
Thank you for your help:)