trying to test the new set up and I can't seem to get the test card to stay on (other display lists show just fine). This is based on EVE LIB for ESP32.
EVE_LIB_BeginCoProList();
EVE_CMD_DLSTART();
EVE_CLEAR_COLOR_RGB(0, 0, 0);
EVE_CLEAR(1,1,1);
EVE_CMD_TESTCARD();
EVE_DISPLAY();
EVE_CMD_SWAP();
EVE_LIB_EndCoProList();
EVE_LIB_AwaitCoProEmpty();
When I run the above code, it flash the test card and goes back to a blank screen. Not running any other code that would cause the screen to clear.
EVE_LIB_BeginCoProList();
EVE_CMD_DLSTART();
EVE_CLEAR_COLOR_RGB(0, 0, 0);
EVE_CLEAR(1,1,1);
EVE_COLOR_HEX(0xFFFFFF);
EVE_CMD_TEXT(100,100, 31, 0, "Hello, World!");
EVE_DISPLAY();
EVE_CMD_SWAP();
EVE_LIB_EndCoProList();
EVE_LIB_AwaitCoProEmpty();
Above code stays on the screen.
What is the correct way of using CMD_TESTCARD().