General Category > Discussion - EVE
BT817Q CMD_SPINNER fails
BRT Community:
Hello,
The development team confirmed that the CMD_SPINNER command will implicitly call a SWAP command in the EVE 4 series.
I will get this information updated in the programmers guide.
Best Regards,
BRT COmmunity
korstiaan:
Hi,
In fact, on EVE3 it was also not necessary but it didn't harm.
I tested it again on EVE3 it works fine with or without the SWAP.
On EVE4 you may not use an extra SWAP.
Korstiaan
Cyrilou:
On ESD this would explain why widgets rendered after spinner are not displayed....
Baxsie:
@korstiaan I'm so glad you found the solution. The spinner in my code has been commented out for a long time. Nice to have a solution!
vdc:
Is there any way we can make display() macro run first before swap? Because I have a code that run the display every 100Hz. With other EVE, that work fine. But with EVE4. When I run the Spinner before Display() cmd. I do see a delay refresh rate. Like button color change when pressed.
Navigation
[0] Message Index
[*] Previous page
Go to full version