BRT Community
General Category => Discussion - MCU => Topic started by: Rayman on October 16, 2019, 11:38:41 PM
-
It would be convenient to be able to reprogram the FT9xx using a microcontroller that will be on the same board.
But, to do this, would need details on the 1-wire programming method.
Is this documented somewhere?
-
Hello,
This information is only available in NDA documents and is only shared on a project basis.
Please contact us by email for more information:
https://brtchip.com/contact-us/ (https://brtchip.com/contact-us/)
Best Regards,
BRT Community
-
Ok, thanks. That's what I figured... I saw "Proprietary" somewhere about this...
Can I use just a 2 or 3 pin header from the programmer board to the board with the FT93x chip on it?
Do I just need the DBG and GND signals to program? Or, do I need reset# too?
-
Hello,
As a minimum, DEBUG and RESET signals are required with GROUND.
Best Regards,
BRT Community
-
Thank you, that sounds good. 3-pin connector is not so bad to add. Might use Servo cable...