I just connect my RVT70HSBNWC00-B with the Riverdi Hermes board.
And EAB 2.4.1 at first detects the display just fine, see the attached image.
Then EAB crashes and just closes without error message.
And it takes down the interface as well, I have to remove it from USB.
I also replaced the original 15cm FFC with a 5cm one, no difference.
EAB 2.4.0 does the same.
Very odd is that the Hermes board does not use a FT4222 but a FT232HQ so the correct setting would be MPSSE.
But with MPSSE it does not work at all.
EAB 2.2.0 - almost the same result, detect works with FT4222 selected, then it hangs for a couple of seconds but it recovers with "Detect Fail!"
EAB 2.1.0 - works with MPSSE, fails with FT4222
EAB 2.1.0 comes with a ProgFlash.exe that has 43520 bytes:
C:\Users\Public\Documents\EVE Asset Builder>progflash
Welcome to BT81X Flash Programming Utility v1.1
EAB 2.2.0 comes with a ProgFlash.exe that has 154624 bytes:
C:\Users\Public\Documents\EVE Asset Builder>progflash
Welcome to BT81X Flash Programming Utility v1.1
Yes, the output is exactly the same.
The newer version also fails on the command-line.
EAB 2.4.0 comes with a ProgFlash.exe that has 155136 bytes:
C:\Users\Public\Documents\EVE Asset Builder>progflash
Welcome to BT81X Flash Programming Utility v1.2
And now it works as it should - what??
EAB 2.4.1 also comes with a ProgFlash.exe that has 155136 bytes:
C:\Users\Public\Documents\EVE Asset Builder>progflash
Welcome to BT81X Flash Programming Utility v1.2
And it works now fine as well, FT4222 mode does not work.
And now it stopped working again, testing from the command line.
Remove from USB, wait a few seconds, EAB progflash.exe from 2.1.0 works again, progflash.exe from 2.2.0 works, progflash.exe from 2.4.0 works, progflash.exe from 2.4.1 works.
I using them like this: progflash_2_4_1 module MPSSE detect except_writing
Ok, I updated to USB driver CDM212364, sorry, forgot to check what I had installed.
EAB 2.4.0 with MPSSE setting does crash again.
Progflash.exe from 2.4.1 on command line fails.
USB disconnect / re-connect
Progflash.exe from 2.1.0 on command line works.
Progflash.exe from 2.4.1 on command line fails.
USB disconnect / re-connect
Progflash.exe from 2.4.0 on command line fails.
USB disconnect / re-connect
Progflash.exe from 2.2.0 on command line fails.
USB disconnect / re-connect
Progflash.exe from 2.1.0 on command line works.
switching to an EVE3-50G from Matrix Orbital
Progflash.exe from 2.4.1 on command line fails.
USB disconnect / re-connect
Progflash.exe from 2.1.0 on command line works.
Progflash.exe from 2.2.0 on command line works.
Progflash.exe from 2.4.0 on command line works.
Progflash.exe from 2.4.1 on command line works.
Whatever this is, progflash.exe does not currently work stable and this is not limited to the RVT70HSBNWC00-B.