1
Discussion - EVE / EVE Screen Designer software support for EVE3-TFT series module
« on: December 19, 2019, 09:53:04 AM »
Hi,
I have EVE3-43A-BLM-TPN-F32 TFT module and started developing the basic GUI on SPI interface by reading BT81X datasheet and programming manual.
EVE3-TFT interfaced with MSP430 and development has already started but due to short dead line for the project we wont be able complete the project in time without any GUI development software.
So,I want to know something about EVE screen designer 4.8 for quick development and ready to use library. i downloaded the software and installed and gone through the document. But EVE3 TFT(BT816 480*272 resolution) is not supported in this software and there is no examples for the same module, i checked in the software and document as well. It has support for FT9xx series and VM816C50A module which i don't have with me.
Please guide me how to make use of EVE screen Designer Software with EVE3-43A TFT , is it possible to develop GUI on screen designer with EVE3-TFT.
or
Do i need to buy new development board (VM816C50A) to make use of EVE screen designer software or is there any alternative to use existing EVE3-TFT module?
I have EVE3-43A-BLM-TPN-F32 TFT module and started developing the basic GUI on SPI interface by reading BT81X datasheet and programming manual.
EVE3-TFT interfaced with MSP430 and development has already started but due to short dead line for the project we wont be able complete the project in time without any GUI development software.
So,I want to know something about EVE screen designer 4.8 for quick development and ready to use library. i downloaded the software and installed and gone through the document. But EVE3 TFT(BT816 480*272 resolution) is not supported in this software and there is no examples for the same module, i checked in the software and document as well. It has support for FT9xx series and VM816C50A module which i don't have with me.
Please guide me how to make use of EVE screen Designer Software with EVE3-43A TFT , is it possible to develop GUI on screen designer with EVE3-TFT.
or
Do i need to buy new development board (VM816C50A) to make use of EVE screen designer software or is there any alternative to use existing EVE3-TFT module?