Hi BRT Community,
Thank you so much for your reply. The intention for my test is the evaluation of the product and development process to make the decision of the mass productions purchase for the new LCD.
I already successfully integrate the said module with my MCU talking SPI and is able to checkout all signal like SPI and interrupt INT_N already.
It is time for interface preparations like images, buttons, animations on the display. Contact Matrix Orbital, they didn't know anything to support and point to me to use the EAB and there is no support from Matrix Orbital since EAB belong to Bridgetek.
So now I am stuck with the couple LCDs without any progress.
To eliminate some unknow hardware obstacles, I tried to use the EAB and connect directly with USB2SPI break board, EVE2-USB2SPI-KIT-A, that I bought from Matrix Orbital as well at this link
https://www.matrixorbital.com/eve2-usb2spi-kit-a?search=usb2spiIf you see this adapter board is not working for my testing, please point me to the right direction to help me to evaluation the EAB and the LCD correctly.
So here are the hardware set up:
LCD: EVE3x-43G-IPS-BLH-TPC-F128-HAP
Interface with EAB v2.10 using USB2SPI break board, EVE2-USB2SPI-KIT-A
Goal: symbol png image preparation and flash to LCD module
Running EAB v2.10
Step 1 Conversion png image
Log:
C:/Images/page1livetext.png conversion is in progress...
Image Conversion completed!
Filename : page1livetext_480x272_RGB565.raw (261120B)
Format : RGB565
Width : 480
Height : 272
Compressed : no
C:/Images/page1livetext.png conversion is done!
Step 2 connect the LCD and detected the LCD
Log:
Detecting flash...
Flash size: 16 MB
Blob is present.
Flash can switch to full speed.
END
BEGIN
Calculate reading speed...
Reading speed: 10.42 MB/s
Reading 10 MB in 0.96 seconds
END
Step 3 Prepare the flash
Flash's Map:
unified.blob : 0 : 4096
page1livetext_480x272_RGB565_Converted.png : 4096 : 22912
Log:
Input files are ready!
C:/Flash is selected as output folder.
Generating flash.bin ...
Generate flash image flash.bin successfully
Flash Map file : flash.map
Flash Description file : flash.ed
Step 4 flashing the .bin file using Updates and Verify
Log:
Updating C:/Flash/flash.bin to flash, erasing if necessary ...
Information on channel number 0:
Flags=0x2
Type=0x8
ID=0x1b3d0200
LocId=0x1c3
SerialNumber=0k5RJ57L
Description=USB 2 SPI
ftHandle=0x0
handle=0x1ee8ca90 status=0x0
VC1 register ID after wake up 7c
reg_touch_rz =0x7fff
reg_touch_rzthresh =0xffff
reg_touch_tag_xy=0x80008000
reg_touch_tag=0x0
Switch flash status to FULL. Result: ERROR
No header detected in sector 0 - Is flash blank?
Flash status BASIC.
Install blob to flash
Switch flash status to FULL. Result: SUCCESS
Installing blob is successful.
Updating Flash file "C:/Flash/flash.bin" to BT81X Flash Storage.
Switch flash status to BASIC. Result: SUCCESS
Switch flash status to FULL. Result: SUCCESS
Switch flash status to BASIC. Result: SUCCESS
Switch flash status to FULL. Result: SUCCESS
Update Flash file "C:/Flash/flash.bin" to BT81X Flash Storage successfully
Switch flash status to BASIC. Result: SUCCESS
Switch flash status to FULL. Result: SUCCESS
Verifying Flash...
Verify flash successfully!
DONE!