Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - ndsmith34

Pages: [1]

Discussion - EVE / Re: ESD RAM_DL vs. RAM_G usage

« on: April 16, 2021, 08:06:02 PM »

So I was able to figure out that the sluggishness of the display was not a RAM issue and was able to correct it.
However, as I'm using a Scroll Switch Page as the main layout for my application. As I add more User Pages to the page containing the Scroll Switch Page layout, the RAM_DL fills up. Eventually when I add enough pages the preview will no longer render and I get a recurring warning saying "Coprocessor has flagged an error."
Is there anything I can do to correct this? Am I limited on the number of pages I can have in a Scroll Switch Page?

Discussion - EVE / ESD RAM_DL vs. RAM_G usage

« on: April 14, 2021, 11:36:55 PM »

I am developing a project on ESD 4.8 and when I upload the code to the hardware the screen update rate is very sluggish and the response to user input is very delayed. I also notice that my RAM_DL usage (as reported by ESD) is nearly 100%, while RAM_G usage is very low (around 1k). Are these things related? Is there a way in ESD to shift how the memory is used?

Discussion - EVE / Re: ESD - Storing toggle value in Scroll Switch Page

« on: April 12, 2021, 05:52:41 PM »

I don't know if it's a global variable or not. I'm using the block from Logic Interface > Variable.
Also, I'm using ESD 4.8.

Discussion - EVE / ESD - Storing toggle value in Scroll Switch Page

« on: April 08, 2021, 08:56:07 PM »

I am adding a toggle to turn on dark mode for a set of screens in a Scroll Switch Page layout. I can get things to work as intended, but then if the pages loop around by swiping to the side several times, the toggle resets and turns off dark mode. I have tried using a variable, but I can never get it to both activate the dark mode and not reset. I'm trying to do all this in EVE Screen Designer. What method should I use to store the value of the toggle switch outside its page so it doesn't reset when the page gets reloaded?

Discussion - EVE / Scroll Switch Page button control

« on: April 05, 2021, 11:40:47 PM »

Is there a way to have a Scroll Switch Page layout that has the swipe functionality and also have, say, buttons at the bottom of the screen to also control the screen that's displayed? Do I need to have different configurations for the "Initial" parameters and then re-initialize to load up the appropriate page?

Discussion - EVE / Re: "Scroll Switch Page" Example available ?

« on: March 22, 2021, 03:52:09 PM »

Did there turn out to be an example project available?
In the simulator I can swipe back and forth between two pages, but once I swipe to the third page the screen goes blank.