1
Discussion - EVE / After the MCU is converted, it cannot be displayed normally
« on: June 06, 2022, 03:02:43 AM »
Hi everyone!
After the MCU is converted, it cannot be displayed normally,
and the SPI is also set to run at 24Mhz, and the initialization is normal,
but it cannot be displayed. What could be the problem?
Is there some way to check?
thank very much
After the MCU is converted, it cannot be displayed normally,
and the SPI is also set to run at 24Mhz, and the initialization is normal,
but it cannot be displayed. What could be the problem?
Is there some way to check?
thank very much