1
Discussion - EVE / Re: EVE Screen Editor Troubleshooting (With STM32 Dev Board and Riverdi 7" BT817Q)
« on: March 10, 2022, 07:09:28 PM »
Hello,
I figured out the issue with connecting our STM dev board and Riverdi eve 4 display, it was a missing driver from FTDI.
https://ftdichip.com/drivers/d2xx-drivers/
Now, I am running into to some trouble trying to get a STM32 mcu to flash a RVT70HSBFWCA0 display
I have a RVT70HSBFWCA0 display with a BT817Q display chip. We are using the EVE screen designer tool 4.2.0 to design a GUI for the display.
We are looking to have an STM32 chip talk to the display over SPI to show this GUI and then if a button is pressed on the screen the STM32 will send a character over UART to another device.
I have exported the EVE screen designer project as an eclipse project, then brought it over to a STM32CUBEIDE project and I running into trouble on how to implement the eclipse export to the STM32 project. It appears that it is meant for another chip? Is there a way so it builds the project for STM32?
I have setup another STM32 project with https://github.com/riverdi/riverdi-eve files wired it up and got it to display the logo and the bouncing ball on the screen.
I did change the SPI init function and CS/PD pins in for the STM32 dev board I am using.
Thank You for your time!
I figured out the issue with connecting our STM dev board and Riverdi eve 4 display, it was a missing driver from FTDI.
https://ftdichip.com/drivers/d2xx-drivers/
Now, I am running into to some trouble trying to get a STM32 mcu to flash a RVT70HSBFWCA0 display
I have a RVT70HSBFWCA0 display with a BT817Q display chip. We are using the EVE screen designer tool 4.2.0 to design a GUI for the display.
We are looking to have an STM32 chip talk to the display over SPI to show this GUI and then if a button is pressed on the screen the STM32 will send a character over UART to another device.
I have exported the EVE screen designer project as an eclipse project, then brought it over to a STM32CUBEIDE project and I running into trouble on how to implement the eclipse export to the STM32 project. It appears that it is meant for another chip? Is there a way so it builds the project for STM32?
I have setup another STM32 project with https://github.com/riverdi/riverdi-eve files wired it up and got it to display the logo and the bouncing ball on the screen.
I did change the SPI init function and CS/PD pins in for the STM32 dev board I am using.
Thank You for your time!